hapi
mas pravdu, ked som dal na 802.11, to ide rovnako ako pred update a mozno o 1-3 mb lepsie ako na v6, cize pri 802.11 tam vidim zlepsenie..
a ak je to, ze to hw zerie menej ta v7 ako v6, tak potom je to o to lepsie..
@selic RTS CTS 0 skusil som este aj to nastavit na jednom klientovi na ktoreho som robil test, nejak som nevidel rozdiel.... prislo mi to iste.... najvacsi rozdiel je vazne mat 802.11n a nie nv2, ta uz vo v7 v keli vazne....
jedina vec co ma tu stve co riesim aj tu:
https://telekomunikace.cz/d/47132-log-xxxxxxxxxxxx-at-wlan1-reassociating
mam cube60ad a chcem ho pripojit na 5 ghz bod. kde je netmetal cez 5 GHZ a ked mam zapnuty nv2 tak cube v pohode je pripojeny. ale ked prepnem na mode 802.11n. tak sa cube pripoji na 40s a pak odpoji a stale dookola a heslo je urcite dobre v logu ap to pise toto:
xx:xx:xx:xx:xx:xx@wlan1: reassociating
na ap mam 7,20.1 firmware a na cube som skusal uz aj ten isty 7,20.1
protection management je vypnuty a robi to ta wpa, pretoze ako nahle dam 802.11, bez wpa tak to pekne drzi..
skusal som aj wpa1 a to robi to iste..... napada vas nieco ine? lebo vazne to robi len na tom cube..
co som pozeral na mk pisu toto:
"reassociating" - happens on AP: connection assumed to be lost, because Station that is considered already associated attempts to associate again. All connection related information must be deleted, because during association process connection parameters are negotiated (therefore "disconnected"). The reason why Station reassociates must be looked for on Station (most likely cause is that Station for some reason dropped connection without telling AP - e.g. data loss, configuration changes).
to ako vymazat, kde vsak v access liste ju nemam.... stretli ste sa s tym niekto?
